FE Power Forums

FE Power Forums => Vendor Classifieds => Topic started by: blykins on March 11, 2020, 05:10:49 AM

Title: Tossing around the idea of selling my C0AE-D heads....
Post by: blykins on March 11, 2020, 05:10:49 AM

As of right now, they have been baked/tumbled, new 7mm bronze valve guides installed, spring seats cut flat, and valve job completed.   They pour at 65.5cc and have not been surfaced yet.  Intake valves are 7mm 2.125" titanium valves and the exhaust valves are stainless 7mm 1.600"'s.  There were a couple of suspect exhaust flange threads, so there are helicoils in there now.  I could change the intakes to stainless if so desired. 


(https://live.staticflickr.com/65535/49611686921_9d684cf1c8_z.jpg)

(https://live.staticflickr.com/65535/49611943117_5ac61732f4_z.jpg)

(https://live.staticflickr.com/65535/49639366301_bdcf51b995_z.jpg)

(https://live.staticflickr.com/65535/49641185642_b65b4d753f_z.jpg)

I will take $1250 as they sit, with a fresh surfacing included.  Can also finish to suit your camshaft and engine specs for an additional amount.
 (https://flic.kr/p/2iCC425)

Title: Re: Tossing around the idea of selling my C0AE-D heads....SOLD
Post by: blykins on March 12, 2020, 08:09:46 AM

These have been sold.....

Title: Re: Tossing around the idea of selling my C0AE-D heads....
Post by: wowens on March 15, 2020, 06:20:24 AM

"What's old is new again." New modern combustion chambers are close to identical to 60's technology and GM has stolen cross bolted block mains. I hope I'm close to being new again !