FE Power Forums

FE Power Forums => FE Technical Forum => Topic started by: 69Shakar on August 10, 2019, 11:51:56 AM

Title: Distributors
Post by: 69Shakar on August 10, 2019, 11:51:56 AM

Is there someone who recurves, rebuilds distributors? Possibly in Washington state?

Title: Re: Distributors
Post by: 427LX on August 10, 2019, 12:15:56 PM

Well you can curve it yourself using a degree tape or marked balancer,tach , advance spring and weight kit and timing light.
Just modify the advance plate slot or make a limiter bushing and you good to go!
I do my own.

Title: Re: Distributors
Post by: 69Shakar on August 10, 2019, 06:55:42 PM

I would but I was hoping to have it ready for new engine being built... was also trying to figure out if I could use a duraspark cap on the 428...

Title: Re: Distributors
Post by: 67428GT500 on August 10, 2019, 07:06:08 PM

There is a gentleman here, I believe his name is Farron Rhodes who does them.  I wouldn't do it yourself.  I was looking for his handle here and the old forum and for the life of me I can't remember it. Just post for the service. Likely he'll respond.

                                                                                        -Keith

Title: Re: Distributors
Post by: fe-starliner on August 11, 2019, 08:08:23 AM

Faron has done two FE distributors for me.  You can contact him at " totalperfentofpa@aol.com"
Reasonable prices

Title: Re: Distributors
Post by: My427stang on August 11, 2019, 09:11:44 AM

Wes Adams (in Oregon) is doing them now,   ford428cj@icloud.com

We have one with him, will be the first, so no experience with his distributor work yet, but I bet it'll be nice

Title: Re: Distributors
Post by: Sand hauler on August 14, 2019, 01:09:24 PM

Second that on Wes Adams, have two he done for me.  ;)