FE Power Forums

FE Power Forums => FE Technical Forum => Topic started by: 67428GT500 on August 03, 2019, 07:59:34 AM

Title: ARP Rocker Shaft Stud Length with Edelbrock heads.
Post by: 67428GT500 on August 03, 2019, 07:59:34 AM

I installed the ARP rocker studs that I was running with my iron heads. The tapered stud that is specific to the oiling that has a flange stop above the threads seats before the flange seats against the head.
Is this a concern, or run it as is? It seems to be about .250 taller than the other studs.

                                                                               -Keith

Title: Re: ARP Rocker Shaft Stud Length with Edelbrock heads.
Post by: My427stang on August 03, 2019, 11:11:06 AM

That stud is shorter for aluminum heads, if you have enough threads it should be fine but typically you match the studs to the type of head