FE Power Forums

FE Power Forums => Non-FE Discussion Forum => Topic started by: winr1 on June 02, 2019, 10:51:10 PM

Title: 4" or 5" long 9" yoke ??
Post by: winr1 on June 02, 2019, 10:51:10 PM

Any difference ??

Preferences ??



Ricky.

Title: Re: 4" or 5" long 9" yoke ??
Post by: TomP on June 07, 2019, 12:45:09 PM

I usually use the short one but if the driveshaft is an inch short the long yoke works with no down sides that I can tell.

Title: Re: 4" or 5" long 9" yoke ??
Post by: winr1 on June 07, 2019, 11:43:11 PM

Thank you TomP :-)

Close to ordering parts for my 9" build



Ricky.

Title: Re: 4" or 5" long 9" yoke ??
Post by: Falcon67 on June 11, 2019, 10:26:05 AM

All my 9" builds use the short.  Have a couple of longs in the box, haven't found a use yet.  Short allows for same driveshaft in the Falcon and the 70 Mustang when switching from an 8" to a 9". 

Title: Re: 4" or 5" long 9" yoke ??
Post by: winr1 on June 11, 2019, 01:00:08 PM

Thanks Chris :-)

Good to know, the ones I pulled from Slicks were all long with 1310/1 1/16" caps

3rd member I traded for has a 1330/ 1 1/8" caps, Dennys Driveshaft had a conversion u-joint


Also, I had to put the grease fitting towards the driveshaft
Installing towards the yoke would not allow room to be greased



Ricky.