FE Power Forums

FE Power Forums => Non-FE Discussion Forum => Topic started by: winr1 on June 01, 2019, 04:05:20 PM

Title: US Strange versus Motive ring and pinons question
Post by: winr1 on June 01, 2019, 04:05:20 PM

https://www.strangeengineering.net/product-category/high-performance-street/9in-center-sections-components/ring-and-pinion-ford-9-inch-gears/

The US Strange pinions have an undercut where as the Motive do not ??

Any opinions on what brand ring and pinion to buy ??

The 4.00 looks like it would be just right for my plans



Ricky.

Title: Re: US Strange versus Motive ring and pinons question
Post by: Nightmist66 on June 01, 2019, 07:54:09 PM

I would check this place out. I have ordered a couple gears from them. I asked and they are re-boxed Richmod Excel gears. 8620 steel. I always deburr every tooth and stone the back of the ring gear. I had a 4.33 that set up perfectly, had no noise, and after a few hard street miles and a couple passes at the track everything still looked perfect.

http://www.ebaystores.com/Quick-Performance-Racing/Ring-Pinions-Gears-/_i.html?_fsub=2&_sid=22645555&_trksid=p4634.c0.m322

Title: Re: US Strange versus Motive ring and pinons question
Post by: Barry_R on June 01, 2019, 08:15:41 PM

As long as the undercut is equal to the groove root diameter of the splines there will be no difference in the twisting strength of the shaft.  But having the undercut might reduce/eliminate the possibility of stress risers propagating from the machined edges on the splines.

Title: Re: US Strange versus Motive ring and pinons question
Post by: winr1 on June 01, 2019, 10:07:28 PM

Thanks Jared, I will check them out :-)


Thanks Barry :-)


This would make my F100 jump ^_^ .... 9" Ford Lightweight 6.83 Gears Ring Pinion  ... lol



Ricky.

Title: Re: US Strange versus Motive ring and pinons question
Post by: babybolt on June 04, 2019, 07:30:44 AM

Tom's Gear and US Gear are made in the US.

US Gear has some ring and pinions pre-broke in - at a cost of course.

Title: Thank you babybolt :-)
Post by: winr1 on June 05, 2019, 06:41:54 PM

Ricky.

Title: Re: US Strange versus Motive ring and pinons question
Post by: gt350hr on June 06, 2019, 11:10:01 AM

   Ford pinions were undercut as well . Richmond began the no undercut style. In the 50+ years I have been doing Ford diffs , I have only seen ONE pinion break in the under cut area and it was from a crash , not torsional twisting. I broke it while trying to straighten it ( incorrectly in a press , in my early days).
    Randy

Title: Thank you Randy :-)
Post by: winr1 on June 06, 2019, 04:39:32 PM

Ricky.