FE Power Forums

FE Power Forums => FE Technical Forum => Topic started by: urchinhead on April 10, 2019, 10:28:23 AM

Title: Drilling Clutch Fork for Spring Clip
Post by: urchinhead on April 10, 2019, 10:28:23 AM

Does anyone know what size the 2 holes need to be and how critical the locations are for modifying a clutch fork to use the earlier style bellhousing pivot? I have an early 428/390GT bracket, and am planning to leave the bracket and modify the fork. I drilled out the rivets and removed the clip that is for the later style pivot bracket, and was planning to drill the fork clip holes today.

Title: Re: Drilling Clutch Fork for Spring Clip
Post by: babybolt on April 10, 2019, 06:36:43 PM

Would do just the opposite, leave the spring clip on the fork and change out the pivot on the bell housing for the later design.

Title: Re: Drilling Clutch Fork for Spring Clip
Post by: urchinhead on April 10, 2019, 07:27:37 PM

That was my first thought, but solution 2 will get this done faster. I already removed the riveted plate and the spring clip should be here tomorrow.