FE Power Forums

FE Power Forums => Non-FE Discussion Forum => Topic started by: Pontiac787 on June 09, 2018, 04:36:58 PM

Title: Grommet help
Post by: Pontiac787 on June 09, 2018, 04:36:58 PM

I’m looking for a grommet with a 1” OD and 3/4” ID to fit a K&N breather in some old Edelbrock cast aluminum valve covers. The port in the valve covers are 1” across by about 3/8” deep. Neither Edelbrock or K&N could offer any suggestions. I got one from Scott Drake for a ‘67 Mustang with the correct OD/ID but the gap is not wide enough. I trimmed the bottom lip off to fit but the center gap section is rounded so it’s not an ideal fit.  Anyone know of a compatible grommet?

Title: Re: Grommet help
Post by: mike7570 on June 12, 2018, 03:25:57 PM

Maybe -


https://www.amazon.com/Racing-Power-Company-R4886-Aluminum/dp/B003TTVCOC/ref=sr_1_80?ie=UTF8&qid=1528835017&sr=8-80&keywords=3%2F4%22+ID+rubber+grommet

Title: Re: Grommet help
Post by: Pontiac787 on June 12, 2018, 10:30:04 PM

Thanks. That one is 1 1/4” OD. I found that the R9760 has the right OD/ID so I’ll see how that one fits.