FE Power Forums
FE Power Forums => FE Technical Forum => Topic started by: james on June 19, 2017, 06:22:25 PM
-
I have been getting various opinion on this issue. I have a 427fe stroked to 482. This is one set of wires that was recommended. Taylor 409 Pro Race Spiro-Wound 10.4mm Spark Plug Wires 79665, 10.44mm.
Then someone told me about Taylor 409 pro race universal spark plug wire set #79691 10.44mm. What say you guys? Any other recommedations and price is not a main concern. Thank You!
-
I use MSD stuff. The 10.5mm on most racy builds, the less expensive Streetfire ones where we need them to work with factory valve coves and wire looms.
-
Thank you Barry. I bought your stroker kit for the motor. Can you please provide me with some part numbers? Thanks again.
-
Going by memory (at home right now) the MSD race set is 31183 - black with multi-angle plug ends and both distributor ends.
-
I've had good luck on my street stuff using the Ford Racing M-12259-M302 cut-to-length black wires, then using MSD boot kit for the distributor side to fit my OEM plug style distributor cap. Gives a nice thick wire with each cylinder labeled along the wire. The pre-made stuff can make the connections but they usually don't dress as nice as when you cut each one to the exact length you want.
-
Think I sued Taylor 8mm universal on the dragster, would have to go look at the invoice. I know I'm using their wire management parts. Picked by price and color blue. Normally over the years I have run 8mm yellow Accel wires and never had any problems. The primary color scheme on the dragster is purple and blue, so yellow would clash. 8)