FE Power Forums

FE Power Forums => FE Technical Forum => Topic started by: turbohunter on December 29, 2016, 02:11:22 PM

Title: Quick Holley choke question
Post by: turbohunter on December 29, 2016, 02:11:22 PM

Hey guys I'm installing new out of the box Holley choke kit on a Holley 4778-6 4150.
The fast idle cam is not lining up well with the adjuster screw. Supplied spacers are way to much.
I figure a washer on each post will get it done. Any problems to think about?

(http://i1220.photobucket.com/albums/dd447/turbohunter1/IMG_0110.jpg)

Title: Re: Quick Holley choke question
Post by: turbohunter on December 29, 2016, 02:12:53 PM

Hmm like vacuum port.
Maybe bend the adjuster arm a bit?

Title: Re: Quick Holley choke question
Post by: machoneman on December 29, 2016, 02:24:16 PM

Yes, bend the arm but be careful if the entire lever can't be removed for bending. That pot metal on Holleys isn't very strong.

Title: Re: Quick Holley choke question
Post by: turbohunter on December 29, 2016, 03:10:04 PM

Wow, that was easy.
It bends way to well IMHO.
But it worked fine.
Also Holley was kind enough not to include a vacuum port gasket so I made one by cutting an extra idle adjust cork gasket in half with a razor blade. Kind of a bitch to make sure it's in place but seems to work well.