FE Power Forums
FE Power Forums => Non-FE Discussion Forum => Topic started by: Drew Pojedinec on July 23, 2016, 01:18:59 PM
-
On mine, shackles are fine, the Shackle hanger is bent on one side and touching the frame.
I was considering replacing the whole works with either an aftermarket hanger that goes into the frame to do away with the bent piece.
I doubt it's possible to rebend the piece.
Any other thoughts? experiences? etc
Planning slicks and caltracs in the near future, so I'll be pulling the rear end anyway. Would like to address the issue at that time.