FE Power Forums

FE Power Forums => FE Technical Forum => Topic started by: fekbmax on May 23, 2016, 04:07:48 PM

Title: TnD street/sportsman rocker shaft dia
Post by: fekbmax on May 23, 2016, 04:07:48 PM

I have ask this a few times with no response. I know that atleast a few of you guys must have or use the TnD street rocker setup. I'm just wanting to know the dia of the shaft.
Anyone ?

Title: Re: TnD street/sportsman rocker shaft dia
Post by: XR7 on May 23, 2016, 04:15:15 PM

I don't have a set and have never measured them, but... I asked the same question when they first came out, and if I remember correctly... the "street T&D"  are .750 diameter shafts, the T&D Race sets I own and have run, they are .625. Jesel are .562 and the stock FORD I think... are .840 (that might not be correct).

Title: Re: TnD street/sportsman rocker shaft dia
Post by: Posi67 on May 23, 2016, 09:43:04 PM

And just for comparison... the Ersons are .682 so if as I suspect you were hoping to find a replacement shaft, we're both out of luck unless someone has spares for sale. 

Title: Re: TnD street/sportsman rocker shaft dia
Post by: Nightmist66 on May 23, 2016, 10:09:18 PM

Yes, T&D street is .750"

Erson have an 11/16" shaft or .6875".

Harland Sharp standard bushed are .840"

Harland Sharp needle bearing are .875"

Harland Sharp "new" style bushed are .750"

Title: Re: TnD street/sportsman rocker shaft dia
Post by: fekbmax on May 24, 2016, 05:23:28 AM

Thanks guys, wondering which .750 shafts are more readaly available. The Harland sharp or the TnD.

Title: Re: TnD street/sportsman rocker shaft dia
Post by: Nightmist66 on May 24, 2016, 09:39:39 PM

FWIW, the T&D 3/4" shaft is hollow like the Erson for standard oiling, whereas the Harland Sharp 3/4" is solid.

Title: Re: TnD street/sportsman rocker shaft dia
Post by: fekbmax on May 24, 2016, 09:59:43 PM

Thanks.