FE Power Forums
FE Power Forums => FE Technical Forum => Topic started by: cjshaker on September 02, 2015, 05:06:59 PM
-
Does anyone know where to get a carb gasket that is big enough to seal the factory spacer with the rear vacuum port? It's a common problem with the bottom of the spacer open/exposed and will suck air like a marathon runner on the 25th mile if it's not sealed up. I've ran out of my stash and am having a hard time finding one big enough to seal that open area. I need the spacer for my power brakes and the RPM has no rear vacuum port.
-
I use this spacer because it has a PVC port. http://www.summitracing.com/parts/trd-2584/overview/
-
Thanks for that link, Jeff. Probably better off going that route anyway so I don't have to use a plate to seal that area.
-
No problem. Here's another one at Jegs that should help keep things cooler than the aluminum one. Jegs has military discount also if you are a vet are still in. http://www.jegs.com/i/Trans+Dapt/969/2584/10002/-1
On the aluminum one, I had to drill the carb bolt holes a little larger for it slide down the studs. Not sure if the phenolic one will need the same.