FE Power Forums

FE Power Forums => FE Technical Forum => Topic started by: StangYellow on August 16, 2015, 08:04:18 PM

Title: Shelby intake manifold?
Post by: StangYellow on August 16, 2015, 08:04:18 PM

I am in the building stages of a 445 that will be going into a Cobra replica. Does anyone have experience using the Shelby intake manifold? http://www.shelbyengines.com/collections/fe-intake-system

I originally was just going to go with the RPM, but stumbled across that Shelby beauty. Thoughts? It appears to very similar to the RPM. Much of the exterior casting appears to be the same as the Edelbrock. This will be going on RPM heads BTW. I have not bought the intake book yet :(

Thanks

Title: Re: Shelby intake manifold?
Post by: Joe-JDC on August 16, 2015, 08:39:29 PM

It is a repackaged RPM with Shelby Logos.  Same intake.  They even admitted it at the beginning of production back before Shelby died.  Joe-JDC