FE Power Forums

FE Power Forums => Non-FE Discussion Forum => Topic started by: chris401 on June 14, 2015, 10:41:38 AM

Title: What Engine Does This Pulley Belong?
Post by: chris401 on June 14, 2015, 10:41:38 AM

FM7205-6. I have learned its not a Y block, does have FE bolt pattern but lacks the center alignment. Photos side by side and back to back compare it to the C5TE-A cast pulley
(http://i1237.photobucket.com/albums/ff469/white65ford/Mobile%20Uploads/IMG_20150614_091245.jpg) (http://s1237.photobucket.com/user/white65ford/media/Mobile%20Uploads/IMG_20150614_091245.jpg.html)
(http://i1237.photobucket.com/albums/ff469/white65ford/Mobile%20Uploads/IMG_20150614_085708.jpg) (http://s1237.photobucket.com/user/white65ford/media/Mobile%20Uploads/IMG_20150614_085708.jpg.html)

Title: Re: What Engine Does This Pulley Belong?
Post by: mlcraven on June 15, 2015, 04:01:16 PM

Industrial or commercial use, perhaps?

Title: Re: What Engine Does This Pulley Belong?
Post by: chris401 on June 15, 2015, 09:15:36 PM

Could be a FT accessory pulley. Unlike my other cast bolt on pulleys which are ligned up with the "fingers" these bolt holes are lined up in the "cut out" areas.

Title: Re: What Engine Does This Pulley Belong?
Post by: GJCAT427 on June 16, 2015, 05:33:35 AM

Looks like the one I used with my 427 balancer when I went to power steering. I think its from a 390 balancer in the mid 60s.

Title: Re: What Engine Does This Pulley Belong?
Post by: machoneman on June 16, 2015, 09:54:10 AM

It's been a long time since I had my '63 390 Galaxie....but I do agree it looks like the P/S pulley for a 352-390 balancer.

Title: Re: What Engine Does This Pulley Belong?
Post by: chris401 on June 16, 2015, 06:23:02 PM

The picture on top of hoist are sitting on C4 ballaners. The one on left sits 1/4" more forward than the other two cast pulleys I have. Should I advertise this as an early pre-65 Galaxie pulley?