FE Power Forums

FE Power Forums => Non-FE Discussion Forum => Topic started by: fe66comet on September 04, 2014, 04:55:48 PM

Title: Mickey Thompson Pro 5 ET Drag wheel?
Post by: fe66comet on September 04, 2014, 04:55:48 PM

Anyone using a set? They are even lighter than any Weld wheel out there, was wondering if anyone has had an opportunity to work with them yet. They are a new product and look promising for my Drag truck.

Title: Re: Mickey Thompson Pro 5 ET Drag wheel?
Post by: cwhitney on September 06, 2014, 10:38:41 PM

I have them on my 67 Fairlane B/S Stocker and never had any issues.. very light.. easy to balance.. I would recommend them. I did not put wheel screws in them either.  I run the 15 by 10, and the 15 by 3 1/2 on the front. Hope this helps

Title: Re: Mickey Thompson Pro 5 ET Drag wheel?
Post by: fe66comet on September 07, 2014, 03:32:34 PM

Just wondering if someone had used them. Sounds good, and cheaper than a lot of race wheels out there. Almost too good to be true LOL.