FE Power Forums

FE Power Forums => FE Technical Forum => Topic started by: bn69stang on January 29, 2014, 08:20:40 PM

Title: Modified Streetmaster
Post by: bn69stang on January 29, 2014, 08:20:40 PM

The question is will a modified Edelbrock streetmaster support more than 500 hp , Jay - Barry  - anyone ? ?  428 ci - 482 ish  ci  thanks Bud

Title: Re: Modified Streetmaster
Post by: jayb on January 29, 2014, 09:05:03 PM

Yes it will; the Streetmaster that Joe Craine ported was one that I tested during my dyno tests, and the engine made 600 lb-ft of torque and 632 horsepower.  HOWEVER, at horsepower levels over 500, there are better manifolds available than the Streetmaster.  The Edelbrock Performer RPM and Ford MR 2X4V intakes come to mind, as well as the Edelbrock Victor, of course.  If you are going to exceed 500 HP, I'd be looking at a manifold other than the Streetmaster.

Title: Re: Modified Streetmaster
Post by: bn69stang on January 30, 2014, 04:51:56 AM

As always Jay thanks for the feedback .. Bud

Title: Re: Modified Streetmaster
Post by: Ford428CJ on January 30, 2014, 10:37:12 AM

What about the Dove Tunnel Ram!?  I had to throw that one out there LOL   ;D

Title: Re: Modified Streetmaster
Post by: 428GT500 on January 30, 2014, 11:28:59 AM

Quote from: Ford428CJ on January 30, 2014, 10:37:12 AM

What about the Dove Tunnel Ram!?  I had to throw that one out there LOL   ;D

Someone likes to instigate I see. LOL

                                           -Keith