FE Power Forums

FE Power Forums => FE Technical Forum => Topic started by: 1932fe on November 25, 2013, 04:59:45 PM

Title: 427 sohc balancer
Post by: 1932fe on November 25, 2013, 04:59:45 PM

Hi just wondering which balancer could I  use on the 427 sohc,

Will a romac Red series factory 427  work. If not what else are people using  Thanks

Title: Re: 427 sohc balancer
Post by: Barry_R on November 25, 2013, 07:16:43 PM

Romac will work fine.

Tougher to find or make proper pulley for the crank...

Title: Re: 427 sohc balancer
Post by: 1932fe on November 26, 2013, 01:08:54 PM

thanks for the reply Barry. The balancer comes with a pulley I was hoping to use it. Is the pulley not the correct diameter Thanks

Title: Re: 427 sohc balancer
Post by: Barry_R on November 26, 2013, 08:45:40 PM

Cammer pulley normally sticks out a lot further than normal.  '62 T-bird if I recall correctly.  We've made spacers to match up a "normal" pulley

Title: Re: 427 sohc balancer
Post by: 1932fe on November 27, 2013, 02:51:51 PM

Thank you for the advice Barry