FE Power Forums
FE Power Forums => FE Technical Forum => Topic started by: cdale on June 22, 2025, 04:52:48 PM
-
Ordering axles for a 63 galaxie stock 9" small bearing. What axle leath I would need going 35 spline. Thanks for any help
-
I would get a hold of who your going to have make your new axle's and ask them what dimensions they need, then go measure your housing
-
Charlie,
I ordered Dutchman 35 spline axles for my 63 a few years ago. They have a form to fill out best I remember. My notes show SR178 axles with 27.875” LH axle and 32.25” RH axle (stock dimensions). There are a few other options such as which studs and spline to meet your requirements.
-
I may be wrong but I think you need to use large bearing for 35 spline axels I just sold my old diff and built a new one when I changed to 35 spline If you think you need 35 spline axles then you should be using a heavy wall tube hosing as well
-
I may be wrong but I think you need to use large bearing for 35 spline axels I just sold my old diff and built a new one when I changed to 35 spline If you think you need 35 spline axles then you should be using a heavy wall tube hosing as well
If we’re talking about the axle bearing, you can get 35 spline 9” axles with the smaller bearing, Strange made mine.
-
Is it possible to source 31 or 35 spline axles that will fit with small carrier and axle bearings?
-
Thanks for all your advice, I called moser order everything with them and yes you can run 35 spline moser has a bearing for small ford 9" housing