FE Power Forums

FE Power Forums => Non-FE Discussion Forum => Topic started by: gregaba on October 22, 2022, 02:09:09 PM

Title: Rear end question
Post by: gregaba on October 22, 2022, 02:09:09 PM

I have a strange set up for my 63 and am getting ready to assemble it.
When I ordered my part's they put me on back order for my Daytona pinion yoke.
They were suppose to call me when they came back in stock but no word yet.
My question is since I have the Daytona pinion setup do I need to order a Daytona yoke to go with it.
I just can't remember as it has been year's since I have built one from scratch.
Greg

Title: Re: Rear end question
Post by: 6667fan on October 22, 2022, 07:52:16 PM

The way that Ford did it yes but Strange should tell you what will work with their pinion support. The spline depth on the Ford Daytona yoke/bearing support combo were originally unique to each other.

Title: Re: Rear end question
Post by: gregaba on October 22, 2022, 08:49:10 PM

Thanks
I shot them a question on it a few hour's ago.
Hopefully will have an answer tomorrow.
Greg

Title: Re: Rear end question
Post by: johncroft on October 23, 2022, 07:04:32 AM

The last Daytona pinion setup that I did, I just machined 250 thousands off a regular Ford yoke. So far so good after 1 year in the race car.

Title: Re: Rear end question
Post by: gregaba on October 23, 2022, 10:45:50 AM

Thanks for the info.I can do that if I can't find the correct one.
I could not remember what the difference between the two was.
Greg