FE Power Forums

FE Power Forums => Vendor Classifieds => Topic started by: blykins on November 12, 2021, 06:19:32 PM

Title: FS: Racetec 428FE pistons with pins....
Post by: blykins on November 12, 2021, 06:19:32 PM

Got a set of Racetec 428 pistons for sale.  Dyno time only.  4.160" bore, 1.670" compression height, 11cc dish, 1/16, 1/16, 3/16 ring grooves. 

No problems with them at all.  $400 for pistons and pins. 

Title: Re: FS: Racetec 428FE pistons with pins....
Post by: FERoadster on November 15, 2021, 10:32:40 PM

Brent:  about what Comp ratio with a standard C4AEH head. Street gas friendly?
Richard >>> FERoadster

Title: Re: FS: Racetec 428FE pistons with pins....
Post by: blykins on November 16, 2021, 05:31:15 AM

Quote from: FERoadster on November 15, 2021, 10:32:40 PM

Brent:  about what Comp ratio with a standard C4AEH head. Street gas friendly?
Richard >>> FERoadster

With a 73-74cc chamber, with pistons at zero deck, you're looking at around 10.3:1 or so.

Title: Re: FS: Racetec 428FE pistons with pins....
Post by: blykins on November 22, 2021, 07:29:26 AM

$350 with free shipping.  They need a good home.

Title: Re: FS: Racetec 428FE pistons with pins....
Post by: galaxiex on November 24, 2021, 10:39:24 PM

Wish my 428 was at 4.160" I'd take em..... but it's at 4.170".

Now where did I put my piston expander.....  ;)   ;D

Title: Re: FS: Racetec 428FE pistons with pins....
Post by: FERoadster on January 06, 2022, 08:29:31 PM

Brent: received the pistons and new rings. Packaged as new in a waterproof box (coastal Oregon rains).
Now I've got to decide what to do with the 428 C scratch engine once it's assembled. .  Could not pass up this opportunity.
Thanks
Richard >>> FERoadster