FE Power Forums

FE Power Forums => FE Technical Forum => Topic started by: wayne on May 09, 2021, 03:13:06 PM

Title: Bumper pistons
Post by: wayne on May 09, 2021, 03:13:06 PM

Has anyone milled 0.100 off the 63-64 bumper pistons and used a 428 crank i think i read about this years ago

Title: Re: Bumper pistons
Post by: MeanGene on May 09, 2021, 03:23:46 PM

Yep, old-school cheap stroker. I would do some careful measuring before cutting, gives you the chance to squeeze the quench. Don't forget the valve notches- and do some measuring there too