Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DEANs427

Pages: 1 ... 8 9 [10]
136
FE Technical Forum / calculation of dynamic compression ratio
« on: July 19, 2011, 06:30:57 PM »
when using any of the published calculators, the intake valve closing point ABDC is requested, is this at .050 or .020 or 0 ? none of the calculators specify this and it makes a BIG difference....

137
FE Technical Forum / Re: cometic head gasket fit
« on: June 12, 2011, 09:34:24 AM »
Jay, the block has a weld repair on the deck between #7 & 8 cylinders that I am try to completely cover with the gasket. is cutting the gasket with a dremmel tool at the notches an option??..

138
FE Technical Forum / cometic head gasket fit
« on: June 12, 2011, 07:51:34 AM »
I am building a 427 and want to use cometic gaskets with a 4.25 bore to match the bore in my block. My block is an OEM side oiler block with the knotches/ reliefs at the top of the cylinders. I am concerned about the the gasket being unsupported at those knotches. the pistons are .006 out of the cylinder at TDC... opinions please

Pages: 1 ... 8 9 [10]