1
FE Technical Forum / Re: electrical connectors
« on: January 01, 2024, 09:10:10 PM »
Another supplier: www.delcity.net
Dedicated to Building and Racing the Ford FE Engine
News:
SMF - Just Installed!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Non-FE Discussion Forum / Re: Best way to pull a stuck pulley/gear off a shaft, no luck so far
« on: December 09, 2021, 09:30:18 PM »
X2 on bigger/biggest puller, also make sure all set screws are removed. I got caught on that one, I removed 2 set screws, drove the sprocket off only to find the third one was hidden by grease and
crud, and of course I bent the sprocket and it was unobtanium so it turned a 2 hour job into an all nighter replacing the shaft, building a new sprocket etc.
Also by removing the set screws you can see if they were doubled up in the hole, yup, got caught on that one too! Good luck! Joe
crud, and of course I bent the sprocket and it was unobtanium so it turned a 2 hour job into an all nighter replacing the shaft, building a new sprocket etc.
Also by removing the set screws you can see if they were doubled up in the hole, yup, got caught on that one too! Good luck! Joe
3
Non-FE Discussion Forum / PRI show Indy
« on: December 02, 2021, 04:57:08 PM »
Anyone going to PRI show in Indy, Jay, Barry, Brent?
My first time going, and looking forward to it. Joe
My first time going, and looking forward to it. Joe
Pages: [1]