Got my block and rotating assembly back yesterday.
Spent the morning putting my hands on it by chasing all the bolt holes, cleaning leftover crud in the water jackets and just eyeing everything like cam bearings to make sure all is well. Only thing I found was in the rear cam bearing. When I first looked at it, it was from the bad angle (see pics), then I saw the good angle. Alignment looks ok to me, whatcha’ all think?
One thing I did not know (maybe a po did it). The oil supply gallery to the pump is 1/2 in diameter. Is that a CJ thing? Took a quick look on the Cobra Jet site and did not find anything but I will keep looking.
QMP did a nice job on everything. Just needs a little more cleaning.