Is there any difference in flow from the
C1s to the C4s? I have both and i cant see
any big difference betwen them--

I dont know in Jays case but i use wires
like that to not perform a pole jump
if the rod end broke

I was cleaning and organizing my garage. So it would
bee nice and Clean when i started building my 390.
And i found the rockerpanel i made for the wifes
Opel rally Kadett. She bought it some yers ago
beacuse it was so small and cute in lipstick red
She drove it for a while but noisy (4.44 rearend)
bad heating some rust issues......
So i traded some work for 2 fiberglass fenders and
a paint job.
Well i thought i better weld in the new rocker , after all its
just a couple of hours work ::)and then of to
the paint shop and i can sell it woohhhoo
Well i have to mount the fenders to...  allright a couple of hours more
Better to sand down that other rocker from loose paint and rust
eehmmm...fiberglass filler well i have to fabricat a new rocker
for that side to......there is a lot of holes in the front gravel pan from
auxilary lights better weld them shut before paint....And those dents
better to smooth them out with hammer and Dolly than just bondo over them
and...........
I dont know if i work slow but those few hours of work have
taken 3 weeks of my life, the shop is a mess again. But just
a few hours more and its of to the paintshop
why o why ......i should sold it or gave it away as it was
I Think this  tread should be about the idiots

I like to look of the FE and what other
American Engine have won the lemans.....
(well the sbf i guess but thats later)

maby Its with Engines as with women if they look
good they are more expensive to  maintain

I traded a Volvo Amazon for a port job on my C4 -G s but they are not done yet
so i cant help you there.
I also have a 64 PI Galaxie

Maby ...to make it idle with that cam, The butterflies is open so
much that fuel is drawn from the mains.It gives a to rich idle but
goes away at higher rpm. The fix is to drill small
holes in the butterflies

PS I realy like 61 starliners, The most beautyful ford of the 60s
in my opinion.My nabour has one but no FE in it just a 5.0 ho
and i still regret a black/red int 4spd 406 i let getaway from me
in the 80s ds

to Cold plugs, high float level,to high fuel pressure
wrong ign timing

I use only silicone sealer as exhaust gasket
I know it sounds like a bad temporary fix
but since i started using it i have never had
an exhaust leak 
Before that there was Always a header leak
after running it for a while