Not having much if any experience in evaluating bearing and cylinder surfaces what do you all think about what you see here?
There are some minor scratches on cylinder walls, there is only one (shown in picture) where I can barely catch the edge with a finger nail, looks worse in image than it is I think.
All others are not detectable by hand, Can I just clean this all up and run with new bearings or ?
Cam bearings look like new to me, rods also look good to me but will replace rods and mains for good measure.
I know it is hard to tell in images but everything is super smooth save that one scratch, while there is obviously something there on most surfaces I can not feel it in all other cases.
Thanks again for all of the help, will try and post rod bearing pictures tonight.
By the way engine has ~3k miles on it, some of them pretty hard.