Not a huge project but thought i would share.
I was inspired by Jays work on his intake adapter dyno mule.
Just started on this so not much to show at this point but figured I would update the thread as i go.
Started with an old points distributor i had laying around, pulled it apart as much as i could without driving the roll pins out of the gear and thrust bearing.
Then i picked a spot and used the shop band saw to cut it in two.
I ordered a few bearings on line, however none of them have quite the correct ID. The shaft is .468, not a common size.
I may turn the shaft down to the next common bearing ID.
One other issue i will have, using a stock distributor, there was just one rather long bushing at the top of the distributor, once i machine it for the bearing, there will be no support of the shaft on the gear end. My plan is to drive the existing bushing out of the top part of the dist and drive it into the bottom section to support the gear end.