What do you have for components bedsides the MDS box? Seems mostly plug & play depending what you need to use for the crank signal, msd box.
Here is what I have hooked up right now. MSD Digital 6 Plus ignition box, MSD Pro Billet 8594, Sniper 4150 EFI, MSD Blaster 2 coil and tach.
This is how I am wired at the moment.
I think this is the wiring diagram I need to hook my EFI up with my distributor and coil?
Correct me if I am wrong as I am trying to figure this out on my own.
- I have a wire from the tach output to my tach right now. Do I pull this and hook it to the brown wire (Tach Output) on the Sniper harness?
- Do I take the single purple wire with connector, hook to my distributor (purple & green) harness? Other of purple wire goes to tach out put on CD box where I just pulled the tach wire above? (where I have "Tach" written on the diagram above- I do not use the yellow wire on the Sniper harness shown in the diagram above?
EDIT: It looks like I keep the wiring between the ignition box and my distributor as I have it connected? I take the single purple wire and plug it into the Sniper harnesss and the other end to my tach output on the ignition box?
- The purple & green wired connector off the CD box is now no longer used?Thanks for all of your help.