OK ceramic coating it will be!
On a side note, I got the 90 degree barb fitting for the fuel hat last night. If you remember, My thought was that the limited space under the back floor and the odd angle of the straight barb was causing a kink in the fuel line. I put my Iphone as best I could down the hole to try and film what the hose looked like, and it appeared to have a small kink. Either way, a $5 fitting would ease my mind.
After I removed the hose clamp from the Fuel Injection grade line, I tried for 15 minuted to pull the barb out HAHAHA no such luck. I snipped the line shorter and installed the 90 degree barb fitting and hose clamp, and now the fuel line has a nice arc and no kink.
Just to know, I continued to try and pull the straight barbed fitting off of the hose piece I snipped off, and I could not get it. I actually grabbed hold of the fitting and had another person pull the end of the fuel injection hose...... Still cant get it LOL. And this wasn't even a pushloc fitting! Just a regular barbed fitting. There is now no doubt in my mind that with a hose clamp on the barb, there will be "0" chance of a leak. Super surprised I could not separate them seeing as how the barb slid right in the line with very little persuasion during the original installation.
Either way, 2 positive things came from swapping out the fitting :0)
Hopefully going to stop by the Header shop this weekend to take a look around and feel the place out.