Thanks Brent and everyone else that hangs their ass out their just so we can bitch.

I sent a note to Summit just asking them to do the right thing and pull their products until they make it right with Broader. I am sure it will get ignored but maybe if enough of us let Summit know this isn't Ok they will do something.

Here locally a man with a family aggregate plant was railroaded by Sacramento county and Teichert construction. He won the first part worth around 20 million for lost revenue. He still has personal litigation with the board that he won't settle because he won't do the NDA stuff. I would love to see something like that with him and speedmaster.

Thank you I was hoping for that.

I am getting ready to paint my question is about the inside of the bed color, the truck will be black and white with the hood and top rails of bed in white so how was it done inside the bed in main color (black) or secondary color ( white). I have seen it both ways and was hoping somebody here could set the record straight.
Thanks

Never did it myself but have read about people using dry ice to freeze it then chip it off.

I have a 9" axle that keeps burning up sealed axle bearings. Everything looked good but I had machine shop push new bearings on just because I was there I put new seals in axle less than 500 miles bearings were junk they are sealed bearings so the machine shop checked axles and put new bearings on again same thing in a week. I haven't had housing put on a fixture but using a solid shaft going all the way through it seems straight nothing is tight going together and both bearings are going junk at same time. What am I doing wrong. Thanks

I was  just curious if some northerners might be interested from pictures it didn't look too bent. But no way to afford to bring to California.