SMF - Just Installed!
0 Members and 1 Guest are viewing this topic.
This is a little out of the groove here for this forum but thought it may interest a few.. I had purchased a Kaase Boss 9 kit for a 460 block a while ago.. It has been sitting in the corner for a while waiting to be dynoed.. All the parts were specd by Jon, I wanted a engine that could be run on pump gas if necessary so only about 11:1 compression . He picked the cam so it would result in a low maintenance valve train. I built a set of generic 2 inch primary dyno headers.. It is a single 4 for a Dominator. Dyno shop's 1250 was usedI was estimating 750-800 horse. I would have been bummed if it was favoring the 750 number. I need not have worried840@ 7000 698@5300