I'm in the process of gathering the final parts for my 427 build, and have an NOS C4AE-B cam and lifters. I seem to find varying specs on this cam, and I'm not sure If it's worth using in my build. (cam was purchased from ford in 1970, not HM)

Here's my build so far,

427 S.O. Block, .017 over, somewhere around 10.5/1 CR (haven't ordered pistons yet), stock steel crank and lemans rods, MR heads that have been fairly extensively ported (professionally, but in 1970, no flow numbers yet), Dougs D627 headers ( 2" primarys), Induction will be either a tunnel wedge or factory MR 2x4 intake with either BT/BU or AC/AD carbs ( have both manifolds and both sets of carbs). I initially planned on a stock stroke build, but now I'm leaning towards a 4.250 crank.

The car, 1968 Mustang FB, 4 speed (2.78 1st gear big in and out), 9" currently with 4.30 gears, caltrac bars/springs, 3250 lbs w/stock 390.

Car will see some street duty, but mostly 1/4 mile Drag racing, really don't want to go nuts with a roll bar so I'm kinda limited to 11.50's


Thoughts, comments,

Thank's in advance, John