Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - SMorton67FB

Pages: [1]
1
FE Technical Forum / Re: 390 smoking while holding back
« on: July 22, 2023, 08:00:42 AM »
Could be the exhaust valve guides are shot and leaking there.

2
FE Technical Forum / Re: FE iron head guide issues?
« on: November 29, 2021, 09:08:34 AM »
Were the guides Brass or Cast Iron?

3
Private Classifieds / Re: ISO.. one 427 high riser head C4AE-F
« on: August 30, 2021, 08:40:42 AM »
Sent you a PM

4
FE Technical Forum / Re: Cobra Jet head hardened valve seat porting
« on: April 14, 2021, 07:21:13 AM »
The ID of that seat seems too small for that valve. What does the chamber side look like?

5
FE Technical Forum / Re: Redneck wrist pin bush honing...
« on: March 25, 2021, 07:13:40 AM »
I would take it to someone with a Sunnen hone or something like that. Some non automotive machine shops could have one and could do it. You may be able to get it yourself but without a rod checking fixture you wont know if you got it straight or not. I would think a master cylinder hone would be better than a ball hone.

6
FE Technical Forum / Re: Weird 390 wrist pin issue
« on: November 16, 2020, 08:46:04 AM »
Sounds like the crank moving that much put side pressure on the rod and caused uneven wear on the rod bushing.

7
FE Technical Forum / Re: fuel pump
« on: March 09, 2019, 09:31:36 PM »
A Carter X pump #4254S has 3/8 NPT on both in and out ports.

Pages: [1]