Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - FOMOGO

Pages: [1]
1
Non-FE Discussion Forum / Help from machinests ...
« on: December 04, 2011, 01:24:30 PM »
 I picked up an older Bridgeport mill over the summer and am now compiling a list of accessories and tooling. I have some of the very basic stuff, 6" swivel vise, R-8 collets, end mills, boring head, cheap clamping set, etc.. Looking for recommendations on a DRO and horiz/vert rotary table & tail stock and anything else that you would consider indispensable/desirable. Thanks, Mike      Posted this over on the other forum also.

http://i87.photobucket.com/albums/k134/gaffney1951/CIMG0005-1.jpg

2
FE Technical Forum / Cam options ...
« on: November 27, 2011, 08:19:23 PM »
 Since I discovered that the cam plug in my newly acquired F-250 was installed backwards I've decided it would be a good excuse to upgrade the cam. Engine is a fresh 390, street dominator intake(have a spare RPM I could use), Ed 600cfm carb, headers 1 3/4" primaries, 2 1/2" duals/H-pipe , will be adding Ed heads with bowl work and minor runner work on the short turn, Blend guide bosses, etc.. Haven't pulled the heads yet, but lets assume for the moment cast flat top builder pistons and static cr of 9.5:1. F-250 4x4, 5000#, TKO 600, 4:10 Dana 60 rear, Dana 44 front, 35" tires. I was thinking 270 solid flat tappet. Will be a daily driver, spirited back road driving and occasional light towing. This is going to be a temporary engine but it will be in there for probably two years until I finish up some other projects and build a 445 for it. Thanks, Mike
Da Beast

the offending plug

dialing in the new bell for the TKO

Pages: [1]