Paulie, my guy said 750 to install caps, I'd say 750-1000 is realistic.
You didn't ask, but a good mag, square deck, torque plate hone, and (if required) tapping all oil galleys, runs about 860 here, if the block needs to be abraded, he adds 100. I install cam bearings myself, so not sure what that would add, my guess says 100, same with sonic checking, I think 150 around here
Knowing the new project, my gut says, a good square decked, magged, sonic checked block, finished with pistons fitted, ready for assembly and the caps would bounce between 1600-1800 depending on what kind of additional work was needed.
Good machinists are a dying breed around here, COVID decimated what was already thin