One set of exhaust manifolds with the heat riser in good condition off of a 1973 truck,$130 352 crankshaft turned .010-.010 with reconditioned rods the crank needs polishing it came out of my truck $150 .Located in Ga. prefer local pickup but might ship some of these parts .Call 678 603 8400 Doug

If anyone has a suggestion for a smaller starter it will help me out .I had to remove my c-6 due to a leak .Well anyone that has a 70s era truck with headers you know how tight a stock starter is with headers .I dropped my headers and after turning the starter got both out . Just curious if there is a smaller starter that would make this job easier .I believe these are Flo Tech headers and my starter is a factory reman .Thanks all Doug

I have a straight front bumper with all the brackets it does need rechroming but a good candidate .it also has the turn signals .$250 located in Ga. Prefer local pickup 678 603 8400.Doug I have bumpers for 66 comets too.

Since the perry swap meet was canceled I will post some of my parts here .Un molested c6ae-r heads $80 mustang-fairlane oil pans clean and dirty $25-$45 mirror 105 block $200 matched rod sets $80-$100 block plates $30 390 main caps and bolts $45 352-390-428 cranks $50-$200 truck exhaust manifolds with heat riser valve complete $100 TCI valve body for a c-6 $100 I much prefer local pickup shipping is expensive .I have lots of pulleys and other fe parts available Located in middle Ga. off I75 call or pm me 678 603 8400Doug 

These are simple two bolt main caps with bolts not rusty .I believe they came off a late 60s engine $50 plus shipping I have a mirror 105 block that has some issues but I do have a sonic test .Cheap $150 .Local pick up on the block .I am in Ga. Doug just call 678 603 8400

I sold all my 69 cyclone parts .I still have some good 66 comet -cyclone parts .Straight bumpers $100 some interior pieces I have one of those pot metal trim that goes between the tail light $85 tail light bezels $50 each bumper brackets $75 .Located in Ga. 678 603 8400 Doug

I have been needing a new carb. for my 390 powered f250 truck .Looking into these brawler series from Holley .They come in several sizes and vacuum or mechanical secondary.I picked out a simple 600 cfm vacuum secondary. It looks like what it is a cheap Holley it has sight windows for your fuel level setting a kick down lever for the transmission and several vacuum ports .With some fine tuning of the idle screws accelerator pump and float level it has performed well so far . Somehow I don't believe this would be a good carb. for an engine with lots of cam or expecting the most hp from your engine .I could be wrong about that and most looking for big hp numbers aren't going with a cheap carb any way .For a mild engine like mine it has worked out alright .Doug

Like the title says this is a stiff sidewall tire they still hook good my comet had  1.45 60FT.Last time out .MT says the section width should be 11.400 .They are 11 3/4 and 11 13/16 .These worked in my 67 comet but my rearend has been narrowed 7/8 By the way my new tires measure 11.400 and 11.500 just like old Mickey said .I will take $100 for them and prefer local pickup but I will ship them after Christmas if need be I am in Ga. #678 603 8400 Doug