1
Non-FE Discussion Forum / Re: 390 on the run stand (not mine)
« on: March 10, 2024, 01:25:04 AM »
I like the idea of a run stand but is it really a good idea on a new engine when you can't load it to seat rings?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Not BB but I use NGK BKR6E in my Edelbrock head 427 (484 stroker).
See if this helps...
https://www.428cobrajet.org/speedo-calc
The Lane has an aluminum rad, it never gets hot.
Needs 19 more on there (see who gets that reference LOL)
Every FE that I put a significantly smaller diameter wp pulley is on has resulted in cooler running temps by much more than five degrees.