FE Power Forums

FE Power Forums => Vendor Classifieds => Topic started by: blykins on February 19, 2019, 07:25:09 AM

Title: FS: New custom FE solid flat tappet camshaft, nitrided....
Post by: blykins on February 19, 2019, 07:25:09 AM

Switching to a solid roller, don't need this one anymore:

265/275 @ .050", 112 LSA, 112 ICL, .660"/.686" gross lift. 

$300, free shipping. 

Title: Re: FS: New custom FE solid flat tappet camshaft, nitrided....
Post by: Stangman on February 19, 2019, 03:02:28 PM

Hey Brent what was this going in. Do you have the springs. Without taking the motor apart how would I know piston to valve clearance, My cam is 625 now. Do you think my 3000 stall converter is enough for this cam.

Title: Re: FS: New custom FE solid flat tappet camshaft, nitrided....
Post by: blykins on February 19, 2019, 03:17:28 PM

This was for a 450 inch pulling truck engine, which is kind of a slow drag race. 

Would also work for a healthy street engine, drag race, etc.  All depends on the engine and cylinder heads. 

Title: Re: FS: New custom FE solid flat tappet camshaft, nitrided....
Post by: Stangman on February 19, 2019, 05:06:34 PM

485 10.75 to 1  BT 2x4 twin QF 750s survival heads 370 rear gears 3500 lb 67 mustang. Might be alittle too much for my converter that I have in the car now. Do you know the operating range.

Title: Re: FS: New custom FE solid flat tappet camshaft, nitrided....
Post by: blykins on February 19, 2019, 06:08:41 PM

It would be strong to about 6700-6800. 

Title: Re: FS: New custom FE solid flat tappet camshaft, nitrided....
Post by: blykins on February 25, 2019, 08:16:12 AM

Will throw in a new set of Morel dumb-bell solid flat tappet lifters. 

Title: Re: FS: New custom FE solid flat tappet camshaft, nitrided....
Post by: blykins on March 02, 2019, 04:12:42 PM

Offers?

Title: Re: FS: New custom FE solid flat tappet camshaft, nitrided....
Post by: BigBlueIron on May 03, 2019, 03:15:24 PM

Wish I had some extra cash as I have future plans for a pulling engine around those cubes that rules dictate no roller cams. dammit man!

Title: Re: FS: New custom FE solid flat tappet camshaft, nitrided....
Post by: blykins on May 04, 2019, 06:35:02 AM

Quote from: BigBlueIron on May 03, 2019, 03:15:24 PM

Wish I had some extra cash as I have future plans for a pulling engine around those cubes that rules dictate no roller cams. dammit man!

What's it worth to you?  $250?

Title: Re: FS: New custom FE solid flat tappet camshaft, nitrided....
Post by: mn67 on May 04, 2019, 09:17:37 AM

I will do 250.