1
Drag Strip Results for FE Powered Vehicles / Re: 1965 Ranchero 445
« on: May 24, 2018, 12:50:40 PM »
Thanks for the reply. That's what I was looking for.
Dedicated to Building and Racing the Ford FE Engine
News:
SMF - Just Installed!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Drag Strip Results for FE Powered Vehicles / Re: 1965 Ranchero 445
« on: May 22, 2018, 02:28:27 PM »
Thanks for the information guys.
One more question. Do you know what the hub to hub measurement is? I want to keep it relatively stock looking as far as the width.
One more question. Do you know what the hub to hub measurement is? I want to keep it relatively stock looking as far as the width.
3
Drag Strip Results for FE Powered Vehicles / Re: 1965 Ranchero 445
« on: May 08, 2018, 11:54:38 AM »
Hey Brad,
Love the look of the car! I have a question. I am also building a 65 Ranchero and I want to put a straight axle under it. Where did you get yours from? Do you know the measurements and are you happy with it?
I haven't been able to dig up any real credible information on installing one of these in a ranchero.
Thanks in advance for any info.
Love the look of the car! I have a question. I am also building a 65 Ranchero and I want to put a straight axle under it. Where did you get yours from? Do you know the measurements and are you happy with it?
I haven't been able to dig up any real credible information on installing one of these in a ranchero.
Thanks in advance for any info.
Pages: [1]