While I'm waiting on the rotating assembly from Barry, I figured it would be prudent to get the block ready. Sent to the machine shop to get cam bearings installed, have the main caps honed with the ARP studs installed, etc. and so forth. Asked them to make sure the deck was good and if needed, take off no more than necessary to get things squared up. Just pulled the block out of the bag tonight to clean out the oil galleries, install the gallery plugs and get it on the engine stand. After getting it on the stand and applying some wd40 to mitigate surface rust while waiting for the rotating assembly, I noticed I could see the rods/pins (not sure what to call them) from the water jackets on the deck. Just curious if this is anything to be concerned about.