Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - RLander

Pages: [1]
1
FE Technical Forum / Can Radiator fluid be "saved"
« on: August 28, 2011, 11:39:12 PM »
Just wondering.

2
FE Technical Forum / Bore Notching
« on: April 11, 2011, 10:08:37 AM »
I have another 390 that I would like to build up. Due to the obvious smaller bore I have been looking at notching the area around the intake valve. I have seen this done on some brand x engines on both sides. Would I gain any flow with the notches? Would it be worth while doing both intake and exhaust sides? Or is this a mod only reserved for Engine masters.
Thanks and Best Regards
RLander

3
FE Technical Forum / Weight and ET
« on: April 07, 2011, 07:50:26 AM »
The rule of thumb that I have heard is that for every 100lbs a car looses it will subtract a tenth from the ET. I was looking at the fiberglass parts for my 64 Gal on the Crites site and was wondering how much weight the trunk lid, front and rear bumpers, and core support, would cut off of the Gal. Or should I get the Fiberglass doors as well? I have already replaced the Front outer fenders and hood along with the heavy iron intake. What Fiberglass parts did you run on your 64 JayB? I would love to read a build up spec sheet for your 64 if you have one.
Thanks and best regards,
RLander

4
Non-FE Discussion Forum / Signature test, excellent new forum jayb n/m
« on: April 06, 2011, 04:13:19 PM »
Test

Pages: [1]