I have used those GM center stear racks in some instalations
Stock the stearing rods mounts in the midle of the rack about
two inch apart.
I take a thick flat iron bar and drill mounting holes in the midle
so it fits on the rack.
Then i heat and bend till it fits the actual aplication, drill a hole
to each end and ream the to fit the cone on the rod end.
Or if i dont have the right reamer i make a cone in the lathe
heat the iron bar and hammer down the cone in the hole
It a real easy instalation.They come both Power or non Power
stearing.
I have even used one for front stear. Took some time to get used to
stear in the wrong direction
....
No i used aright hand drive one turned upside down
Funny thing ! i have a friend with a 69 Corvette that wanted
R/P stearing and i told him to make it like that
But he ordered a kit from some Corvette specialist and got
exact the same setup i have been making for years
o