FE Power Forums
FE Power Forums => FE Technical Forum => Topic started by: 6667fan on April 09, 2019, 07:23:56 PM
-
That is a Mr Gasket 202 A shown. Notice the port peeking on the left side.
Thanks, JB
http://i.postimg.cc/BQ4M5crB/16-BBF75-B-F4-DD-43-D4-B44-D-F605-AE60-DE20.jpg
-
I think a gasket for Blue Thunder heads might work on that; Barry R might have those. Or, buy gasket material and cut your own, I've had to do that on several occasions.
-
Not sure who's ports those are but I had similar issues with the 202a's on my Kuntz ports. I got some blue thunder gaskets and they would work with a little trimming but ultimately made my own gaskets and was much happier with the results.
-
What intake manifold do you use with the very wide intake port?
Do you require offset lifters to move the pushrod?
I would assume the intake needs modifications as well.
Cheers
-
I have gaskets that will fit that
-
Barry, can ya’ get a set to me? I bought a worked Victor from Jay and my builder will have it next week. Be nice if he did not have to make ‘em up in the shop. He thinks the 1247-S3 might cover even after trimming. You would know for sure.
Call or text me.
Thanks,
JB